![]() ![]() #Paint in mac osx windowsA USB hdmi capture dongle is each connected to the MacOS and Windows VMs. The Webcam/Video setup was inspired by the audio setup and when coupled with the use of these cheap usb hdmi capture devices that have been popping up with "raving" reviews, enables us to accomplish this pretty cheaply sans the GoPro. Placed a simple fur cover that takes care of wind (from my fan) and a pop filter hovering on top of it. The microphone set-up involves mounting the microphone to the Ulanzi MT-11 tripod and hanging it upside down from my monitor mount, so it's basically hanging at the bottom. The Rolls MX51s mixer takes the output from the second and third interface that is connected to both the MacOS and Windows VMs respectively and outputs to the S.M.S.L AD18 via AUX which then outputs the audio from both OSes at the same time. I wanted the audio on both channels and that's where the splitter comes in. I bought an XLR Splitter because the way this interface works is that it splits the first input to the left channel and, the second input to the right channel when using direct monitor. The first interface is used as an input for the microphone which is an Audio-Technica AT2035. The only difference here was that I decided to get the more expensive Behringer UMC202HDs for both VMs as that gave me the benefits of stacking the audio interfaces and have more inputs/outputs. The audio setup was basically modelled after the post of audio hardware for vfio setups by the guys over at The Passthrough Post. The hub doesn't come in a black variant and therefore I just spray painted mine. There are some issues mounting the Orico MHP4U to the bottom of the monitor as this monitor isn't flat at the back but, I'll probably just use some 3M VHB tape to solve this. The Left being MacOS and the right being Windows. One USB 3.0 port is used by the Dell U2715H's USB hub that has the audio interface and other devices connected to it, while the other is for the Orico MH4PU that's mounted on the bottom of my monitors that allow me to easily connect usb devices to either OS. I passthrough two FL1100 controllers coupled with one onboard Intel controller that go to MacOS and Windows respectively. The U3X4-PCIE4XE111 gives us four FL1100 controllers that can be passed-through to the VMs. You can read more about the various cards I tested here Streaming (Audio + Video) data over the Renesas chipset would not work therfore I had to use the FL1100 card. That card however uses a Renesas uPD720202 and doesn't work well with MacOS. There was another card which I actually preferred due to it having 2 x USB 3.0 headers and would allow me to connect the ports on the front of my case. The current card uses a Fresco Logic 1100 Controller and has native MacOS Support. In the end, I could only manage to achieve one of them which was MacOS support. The board I am using does not come with USB 3.0 and because I wanted USB 3.0 support, I had to find an add-in card that worked properly with device resets + MacOS. The most annoying part of this entire build was getting USB 3.0 support. The hardware above was basically requisitioned along the way as I found more issues to solve and this is probably the exhaustive list.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |